Taking it to the next level

 

Peninsula terrain boards and the Monastery of Santiago for my 40mm skirmish games.

I have been busy as a beaver working on the Spanish terrain boards and terrain ground clutter pieces and I am nearing the end of the construction phase of the project (or at least as far as I can foresee). Recent terrain additions include some vineyards, an olive grove and a mount to place the monastery in the Sharpe games.

I decided that the Monastery of Santiago, the center piece of my terrain, needed to be elevated a bit more to make it truly stand out, so I cut off a chunk of 2-inch thick pink foam insulation board and carved out some steps and  ramps to provide access to the monastery.

Front view of the monastery and the dual entrance ramps.

The church has a back door so I had to have an access point at the rear of the building.
When I elevated the buildings on a 2-inch thick slab of foam board, I was able to carve
some steps into the raised base. Rocks were scored into the foam with a ball point BIC pen
and then painted various shades of grey to simulate stonework.

A view of the raised monastery cited on the far side of the Coa River crossing.
The sides of the raised base will have bark nuggets glued on and painted to match
the stone inside of the river gorge. The driveway still needs some dry brushing and highlights.

This picture depicts the Coa River, but it also shows the monastery layout before I 
decided to raise the buildings two inches higher. On the far back table on the right a 
new board is a work in progress- the pink insulation foam has been painted a dark
brown undercoat color.

A close up view of the vineyards.

NEXT:

Now I have to turn my attention to the construction of some river sections to place inside the river gorge. I have cut up some cork placemats and given them a coating of tan primer. Then the water will be painted onto the boards using black paint and dark green paint; then the ground gets covered with wallboard paste and all other dry brushing work gets done. Finally, a gloss coating of either gloss spray on primer or Mod Podge will cover the water to give it a shiny shimmering water effect. This step must be done last, otherwise bits of sand and dust will get on the gloss surface and stick - this doesn't look good.

THE BOTS ARE GONE?

The bots disappeared at the beginning of October and now my viewer count is deemed more accurate with respect to the number of visitors and page views that each blog entry is getting. The previous entry currently has around 350 views compared to 15,000 views for several of the September postings. I hope that this is the last of the bots for awhile.

In closing, here are two pictures of the Perry 40mm British light infantry company of the South Essex Regiment.