Friday, May 22, 2020

More Complicated Dervish Flag Conversions

Converted figure (left) and original figure (right)


Considering how soft the plastic is in the AIP figures, I figured that it would be easier to clip, cut and carve other Dervish figure poses that were better suited for use as standard bearers.


Flag bearer for one of my Beja/Hadandowa war bands.


Many of the poses have the warrior holding his shield out to his side, why I don't know, so I decided to cut off the shields and drill a hole in the hand to create a standard bearer.



Flag bearer for one of my Ansar war bands.

The conversion process is quite easy, actually. I begin by cutting off the shields and being careful to not cut the hand off in any degree. The shields have a thick boss at the center and this takes a bit more work to cut and carve the unwanted plastic material from the fist. Once the shield has been cut off, I begin the process of gradually carving or shaving the arm and fist to make them look more natural. I could have done a better job on the two figures shown in this post, but they were good enough for me.

The flags are images from War Flags, a site for free downloads of flags. I copied them and pasted them to Word, printed the document out and then trimmed to flags to the desired size. The next step is to smear white glue (Elmer's Glue or the equivalent) over both halves of the back side and then fold the paper around the flag pole. There is still some time left to true up the flag halves so as to minimize the amount of white showing around the edges.

Next, I use one of my paint brush handles to furl the flag. I place the brush handle on a section of the flag and I wrap the flag around the handle to create the furl. Always have your flag furl running diagonally away from the flag staff to get a more natural look.


9 comments:

  1. I have to say they work perfectly, great job.

    ReplyDelete
  2. Replies
    1. Thank you, they are fun to work on. I might tackle removing shields from some of the warriors or repositioning some of the arms.

      Delete
  3. You are a master at printing, painting, and furling flags, Jim. Beautiful results and good advice.

    Best Regards,

    Stokes

    ReplyDelete
  4. As many people have said, it is the flags that stand out and make a wargame unit look great.

    ReplyDelete
  5. Wonderful looking figures Jim and a great job on the conversions. You've been an absolute demon on the amount of painting you have completed on this project recently. There is nothing ,ike a goal/date to get the cobwebs blown out thats for sure.

    ReplyDelete
    Replies
    1. I can't help myself. Those brushes are moving at their own speed and I'm just along for the ride.😄

      Delete